CEMTEK Service and Parts Offerings

Cemtek KVB-Enertec-1CEMTEK KVB-Enertec, Inc.

Innovative Emissions Monitoring
for Compliance and Process Improvement


Why Choose CEMTEK for Your CEMS Service Requirements?
The Benefits of a CEMTEK-KVB-Enertec Maintenance Contract

Continuing changes in air quality regulations and the increasing complexity of emissions monitoring can make CEMS management difficult. CEMTEK KVB-Enertec can play a vital role in helping your company navigate this process as well as achieve and maintain the quality environmental compliance data you need to meet your availability requirements!
All field service paperwork is carefully documented, collected, archived, and made available for any future needs (e.g., internal audits, air district inspections, etc.). Additionally, CEMTEK service can assist your company in maintaining your Quality Assurance Plan.


CEMTEK KVB-Enertec Maintenance Offers

• Service technicians located throughout the country for expedited service
• Service technicians experienced in servicing a wide range of analyzers, probes, sampling systems, and data acquisition systems
• Expert engineering and field service support
• CEMS hardware training
• DAHS training
• Quarterly audit and annual RATA assistance
• QA/QC Plan updates and modifications
• Part 75 monitoring plan updates and modifications
• EDR service contract options: reporting, data validation, and allowance tracking
• Special state and local reporting options
• RTU and RECLAIM data reconcilement program options
• EPA audit assistance
• Regulatory consulting and assistance
• Assistance in data interpretation
• 24/7 emergency call-out support
• Parts availability
• Single source responsibility
• Reliable and dependable on-site presence


Preventative Maintenance

Preventative maintenance visits are customized to meet the needs of each customer and each CEMS with quarterly or monthly visits recommended for most sites to ensure the highest availability. Experienced CEMTEK service personnel will perform periodic and preventive maintenance service including probe inspection and cleaning, air cleaning system checks (scrubber replacement and filter changes), diagnostic check on all analyzers, performance of the manufacturer’s recommended preventive maintenance on each analyzer and complete calibration.

CEMTEK KVB-Enertec Supports the Following Systems

Continuous Emissions Monitoring Systems (CEMS)
• Complete inspection to verify proper operation of entire system
• Perform leak checks on each system component
• Replace sample probe filters as required
• Replace sample conditioning filters as required
• Replace analyzer filters as required
• Rebuild analyzer sample pumps according to manufacturer’s recommendation
• Rebuild sample transport pumps according to manufacturer’s recommendation
• Verify zero air generator for proper operation
• Replace zero air generator filters/chemicals as required
• Perform manual calibrations as required
• Complete analyzer maintenance checklists
• Document and submit maintenance service visit reports

Continuous Emissions Rate Monitoring Systems (CERMS)
• Perform flow monitor flow and leak checks
• Verify the calibration of the output and re-calibrate if necessary
• Inspect cable connections on terminal strips and terminal blocks
• Inspect interconnecting cable and wiring
• Check the conductors for corrosion and replace if necessary
• Conduct leak check and replace any corroded seals as necessary
• Check the flow element for debris and clean as necessary
• Check and replace chemical absorbers as necessary
• Check pitot for alignment, plugging, and/or corrosion; adjust and replace if necessary
• Inspect transducers
• Inspect and change purge air filters as necessary
• Inspect and clean sender/receiver units
• Inspect purge air supply
• Clean filter housing
• Replace filter insert as necessary

Continuous Mercury Monitoring Systems (CMMS)
• Complete inspection to verify proper operation of entire system
• Perform leak check
• Replace sample probe filters as required
• Replace air clean up panel media and filters as required
• Replace analyzer filters as required
• Rebuild sample transport pumps according to manufacturer’s recommendation
• Perform manual calibrations as required
• Complete analyzer maintenance checklists
• Document and submit maintenance service visit reports

Continuous Opacity Monitoring Systems (COMS)
• Perform opacity monitor inspections and preventative maintenance
• Inspect/clean/replace purge air filter as required (supplied by customer)

Additional Services

Quarterly Audits
CEMTEK provides on-site Quarterly Audit assistance and will perform Cylinder Gas Audits per USEPA 40CFR Part 60, Appendix F or conduct Linearity Test Audits per USEPA 40CFR Part 75, Appendix B. The audit data will be included in quarterly reports for local reporting and the EDR’s for Part 75 reporting.

Annual Audits
For the Annual RATA, CEMTEK technicians will be on-site the day of pretest runs and the day of testing. The data will be included in reports for all required reporting.

USEPA EDR or SCAQMD RECLAIM Services
A one-year EDR service contract assures accurate and error free data. CEMTEK will retrieve data once per month via pcAnywhere or similar internet service as well at the end of each quarter. From our office, CEMTEK will validate data, run the EDR and then download the completed EDR and its associated history files to the site for your submittal to the EPA. CEMTEK will also partner with site personnel to coordinate linearity checks, RATA and so on. CEMTEK maintains and stores the history files and EDR’s at both our facility as well as the site facility computer. We can also provide a RTU and RECLAIM data reconciliation program.

Emergency Response: 24/7 Call-Out Support

Our technicians provide 24/7 call-out support, have extensive experience in the CEMS field, and are located throughout the country for expeditious dispatch. Emergency support also includes unlimited telephone support with one-hour callback times.

Check Out Our Other Exciting Features & Benefits!

Parts-Anytime, Anywhere
On-Site Training

Contact Us for Your Quote!
E-mail or call us 504-500-1322

Stay Connected
CEMTEK KVB-Enertec Inc. | 888-400-0200 www.cemteks.com
3041 S. Orange Avenue, Santa Ana, CA 92707
2849 Sterling Drive, Hatfield, PA 19440

Represented by TruWinR Corp, Metairie, LA
504-500-1322